Please be aware you will be dispensing water up to 98°c and need to take all necessary precautions.

STEP ONE: Once the HydroTap has been turned back on at the water and electrical supply, you will need to flush through the filter. You will need a jug/container suitable to carry boiling water or if the tap is over a sink you can dispense directly to this (please be aware the HydroTap fonts are not designed to take this volume of water)

1. On the LCD screen, select [MENU] then [Install] and then [Filter Flush]. 
2. Open the filter flush stop valve and ensure the end of the hose is in a jug/container or sink.
3. Then select [Filter Flush - START]. This will start the flow of water. Flush for 30 seconds to remove any water sitting in the filter cartridge.
4. When the Filter Flush is finished, turn the stop valve to OFF by rotating the lever anti-clockwise until it is 90° to the hose. Replace the hose into the filter compartment.
5. Press [Filter Flush - STOP] to end the filter flush process. Use the [Home] key to exit the Flush Menu. Wait for lights on tap to stop flashing and the HydroTap will be ready for use.

STEP TWO: Flushing through the tanks – 6 litres of each water type (Boiling, Chilled, Sparkling dependant on customer product).

1. Place a jug/container suitable for boiling water under the tap or use of the sink is acceptable (please be aware the HydroTap fonts are not designed to take this volume of water).
2. Using the tap controls, dispense x6 full 15 seconds of each water type. Each 15 second dispense is approximately 750-1000ml.
3. Once the necessary flushing has been completed, wait for the lights on tap to stop flashing this will indicate the HydroTap is ready for use.